Model 600806 µHELIX® Test Probes
| Ordering Part Number | 600806 |
| Descriptive Model Name | S300*3800/700/30@350/S1300s.Au/S1300s.Au |
| material | body (tube/coil component): 304SS plunger: SS20AP Steel pin2: SS20AP Steel |
| length | body: 3800 µm (0.15 inches) plunger: 1300 µm (0.051 inches) pin2: 1300 µm (0.051 inches) |
| Length Over All (LOA) | 6400 µm (0.252 inches) |
| alternate lengths | See Probe Group S300*3800-P2 or contact AlphaTest |
| diameter | body: 305 µm (0.012 inches) plunger: 221 µm (0.009 inches) pin2: 221 µm (0.009 inches) |
| plunger tip shape | sharp (90° cone) |
| i/o end tip shape | sharp (90° cone) |
| alternate plunger tip shapes | See Probe Group S300*3800-P2 or contact AlphaTest |
| alternate pin2 tip shapes | See Probe Group S300*3800-P2 or contact AlphaTest |
| spring type | rectangular helix integral to tube |
| spring force | 30 grams at 350 µm (1.1 oz@0.014 inches) |
| spring compliance | 700 µm (0.028 inches) maximum 350 µm (0.014 inches) recommended |
| plating | body: 35 µinches Type II Gold plunger: 35 µinches Type II Gold pin2: 35 µinches Type II Gold Contact AlphaTest for other plating. |
| lubricant | none: gold on gold wiping contact |
| probe resistance | < 80 milliohms |
| μHELIX® spring life | > 106cycles at recommended compression |
| installed pointing accuracy | drill accuracy ±20 µm (0.0008 inch) |
| INSTALLATION NOTES: | |
| probe-guide drill size | #80; 343 µm (0.0135 inches) |
| plunger-guide drill size | #88; 240 µm (0.0094 inches) |
| i/o end-guide drill size | #88; 240 µm (0.0094 inches) |
|
|
|
|
|